What strings should I get for my P-Bass?

Ernie Ball Regular Slinky Nickel Bass. Some of the best bass strings for bright, modern sounds.

  • Rotosound Jazz Bass 77.
  • D’Addario NYXL Bass.
  • Rotosound Tru Bass 88.
  • D’Addario XT Nickel Plated Bass Strings.
  • Ernie Ball Regular Slinky Cobalt.
  • DR Strings Lo-Rider.
  • La Bella Deep Talkin’ Bass.
  • What are Tapewound bass strings?

    Tape Wound bass guitar strings are manufactured with nylon tape wrapped around the outer wire wrap. The tone produced by tape wound strings is mellow and warm. Tape wound strings are often used on fretless basses since they cause less wear and tear to the fingerboard than a traditional round wound string.

    What are P-basses good for?

    The solid fundamental delivered by the Precision Bass makes it a great choice for classic rock, country, punk, surf, and grunge. We would definitely recommend doing some research into what your favorite bassists are playing.

    Is P-Bass good for slap?

    P-basses tradtionally are terrible for slapping. I can do it on a P-bass. Its not harder to play but it doesant give the traditional slap tone because P-pups make a tone that are nearly the complete opposite of a traditional slap tone.

    What bass strings did Jaco Pastorius use?

    jaco pastorius used rotosound solo bass. and jaco used goose fat on a hankercheif as a lubricant.

    What are Tapewound strings good for?

    Was Jack Bruce a great bass player?

    Most musicians would have a very hard time distinguishing themselves if they wound up in a band with Eric Clapton and Ginger Baker, but Jack Bruce was so gifted on the bass that he did it with ease.

    What bass did Jack Bruce use in cream?

    One of his first was the Fender Bass VI, a 6-string bass tuned EADGBE like a guitar, but one octave lower. Jack recorded most of Fresh Cream with this bass, before moving to the classic Gibson EB-3, the sound of which he made famous during Cream’s live tours.

    Previous post Is Bill Foster a Republican or Democrat?
    Next post How do I trim in AutoCAD 2020?