How do I factory reset my Cisco 3650 switch?

How do I factory reset my Cisco 3650 switch?

Part A: First you need to power down the switch. Once the switch is powered off, hold down the mode button, and power the switch on. The switch will boot up and you should see the switch prompt as shown below. Next, check out the contents of flash and locate config.

How do I erase a Cisco switch configuration?

Clear the configuration of your Switch

1. Log on to your switch, and enter the privileged EXEC mode by entering enable and then entering the enable password command.
2. Enter write erase, which erases the NVRAM file system and removes all files.
3. At the prompt, confirm that you want to erase all files.

How do I reset my Cisco 3650 switch password?

1. Connect a terminal or PC to the switch.
2. Set the line speed on the emulation software to 9600 baud.
3. Power off the standalone switch or the entire switch stack.
4. Reconnect the power cord to the or the active switch.
5. After recovering the password, reload the switch or the active switch .

How do you reset a Cisco Catalyst 3850 switch?

1. Power down the switch.
2. Hold the Mode button.
3. Keep holding the button and apply power.
4. Keep holding down the Mode button for another 45 seconds and then release.
5. See if the console goes to ROMMON or not.
6. If in console, enter this command: SWITCH_IGNORE_STARTUP_CFG=1.
7. Reload the switch (use the power cable).

How do you reset a Cisco Catalyst 3550 switch?

How to Reset a Cisco Catalyst 3550 / 3560 Switch to Factory…

1. How to Reset a Cisco Catalyst 3550 / 3560 Switch to Factory Defaults.
2. Enter the following commands in the privileged mode: (# prompt)
3. delete flash:vlan.dat.
4. erase startup-config.
5. reload.

How do I delete a configuration on a Cisco 3650 switch?

Copy the current the config and then erase the startup config: ! copy run flash:latest. confg write erase reload !…How to factory reset a Catalyst 3650 switch via CLI

1. Labels:
2. Catalyst 3000.
3. Other Switching.

How do I wipe a cisco 3850 switch?

To reset the switch to the factory defaults: Step 1 If you are using Cisco IOS XE Release 3.6. 0E or later releases, enter the erase startup-config privileged EXEC command to clear the contents of your startup configuration. If you are using an earlier release, you can skip this step.

How do you soft reset the Switch?

Soft Reset Nintendo Switch Step 1: Press and hold the small circular Power button on the top of the Switch console until the system powers off. This process takes you 15 seconds at most. Step 2: After waiting for a while, press the Power button again. Step 3: You will see the Nintendo logo on the screen.