What are the EtherChannel limitations?
A limitation of EtherChannel is that all the physical ports in the aggregation group must reside on the same switch except in the case of a switch stack, where they can reside on different switches on the stack.
Were there any problems with EtherChannel?
Common EtherChannel issues include the following: Assigned ports in the EtherChannel are not part of the same VLAN, or not configured as trunks. Ports with different native VLANs cannot form an EtherChannel. Trunking was configured on some of the ports that make up the EtherChannel, but not all of them.
Does EtherChannel increase bandwidth?
Benefits of using EtherChannel Increased Bandwidth: Use EtherChannel and combine two or four links into one logical link. It will double or quadruple your bandwidth. For example, four 100Mb Fast Ethernet connections bonded into one could provide you up to 800Mb/second, full duplex.
What is an advantage of EtherChannel?
EtherChannel provides redundancy because the overall link is seen as one logical connection. Additionally, the loss of one physical link within the channel does not create a change in the topology; therefore a spanning tree recalculation is not required.
How many port channels maximum can be configured on a switch?
Follow these guidelines to avoid configuration problems: A maximum of 128 EtherChannels (non-StackWise Virtual setup) and 126 EtherChannels (StackWise Virtual setup) are supported on a switch or switch stack.
Does EtherChannel double bandwidth?
What is difference between port-channel and EtherChannel?
EtherChannel terminologies Spanning Tree Protocol – Is a data link layer protocol that prevents loops in networks with redundant links. Port-Channel – This refers to communication links between switches that combine multiple ethernet ports bandwidth into a single logical link.
What is difference between EtherChannel and link aggregation?
Cisco EtherChannel It’s become a generic term used that is often used interchangeably with the more correct term, link aggregation. While link aggregation is the term used to describe the overall technology, EtherChannel is a Cisco proprietary method for actually configuring link aggregation on Cisco equipment.
Does EtherChannel increase throughput?
Can an EtherChannel be a trunk?
EtherChannel technology only bundles ports of the same type. On a Layer 2 switch, EtherChannel is used to aggregate access ports or trunks. For example, if the physical ports of one side are configured as trunks, the physical ports of the other side must also be configured as trunks.